Hi
My company have recently brought a SRX300 to replace our SRX100h and I have hit a few problem when setting up. Hoping to find some help here.
The SRX300 will have 2 internet uplink connected and also connecting to a EX2200 switch.
1. I was trying to setup a vlan that could be routed and can access the internet. But I found that after I created the VLAN in J-Web, with the l3-interface irb.0. The interface was not in the routing table nor I can ping the interface address.
2. I want to setup an aggregated ethernet interface with the EX2200, I set both side to active LACP mode. It show that the physical interface is up on both device, but the logical interface ae never came up. I was having the same configuration between the SRX100h and the ex2200 before which work find without any problem.
Thanks a lot.