Re: traffic only flows in one direction through routed based VPN between srx and paloalto

Hi,

First two commands only recogonising 

whe I type 

packet-filter

It is not recogonising command but I tried to read the log without filtering and result is below.

Oct 17 13:26:10 13:26:10.033911:CID-0:RTroc_loopback_common: Found loop if vlan.0

Oct 17 13:26:13 13:26:10.033911:CID-0:RT:check self-traffic on vlan.0, in_tunnel 0x44c0b254

Oct 17 13:26:13 13:26:10.033911:CID-0:RT:retcode: 0x204

Oct 17 13:26:13 13:26:10.033911:CID-0:RTak_for_self : proto 1, dst port 1, action 0x4

Oct 17 13:26:13 13:26:10.033911:CID-0:RT: flow_first_create_session

Oct 17 13:26:13 13:26:10.033911:CID-0:RT:Loopback first path alloc pending session, natp=0x4515c430, id=11813

Oct 17 13:26:13 13:26:10.033911:CID-0:RT: flow_first_in_dst_nat: in <vlan.0>, out <N/A> dst_adr 172.30.10.1, sp 31141, dp 1

Oct 17 13:26:13 13:26:10.033911:CID-0:RT: chose interface st0.0 as incoming nat if.

Oct 17 13:26:13 13:26:10.033911:CID-0:RT:flow_first_rule_dst_xlate: DST no-xlate: 0.0.0.0(0) to 172.30.10.1(1)

Oct 17 13:26:13 13:26:10.033911:CID-0:RT:flow_first_routing: vr_id 0, call flow_route_lookup(): src_ip 172.16.3.52, x_dst_ip 172.30.10.1, in ifp vlan.0, out ifp N/A sp 31141, dp 1, ip_proto 1, tos 0

Oct 17 13:26:13 13:26:10.033911:CID-0:RToing DESTINATION addr route-lookup

Oct 17 13:26:13 13:26:10.033911:CID-0:RT:flow_ipv4_rt_lkup success 172.30.10.1, iifl 0x46, oifl 0x0

Oct 17 13:26:13 13:26:10.033911:CID-0:RT: routed (x_dst_ip 172.30.10.1) from lan (vlan.0 in 0) to .local..0, Next-hop: 172.30.10.1