Hi
I want to make a cluster of SRX firewall over an ethernet Link. I couldn't find exact config though found many guides.
I am bit confuse how to configure Control & Data link interfaces since these devicese are not near by.
SRX Firewall---2 links------02*Cisco Switches-----01*Primary / 01* Back Links----2*CiscoSw------2links---------SRX Firewall
Can someone share exact configuration steps to make an Active / Active Cluster over ethernet as above. Kinldy also share if there is no bandwidth issue than which design do you recommend Active/Active Cluster or Active/Passive Cluster.
Thanks