We manually switch active primary Firewall to secondary,So secondary Firewall came active mode . But the traffic to switch is not happenig "Automatic"
But when I manually shutdown and enable LACP in switch Traffic is happening. I think after Failover the routing is happening to previous firewall. As you mentioned there is no change for routing. During that time I thought If we Power off primary (not manual switching) will solve the issue because that interface will go down.
But recently we again checked the same but traffic is not forwarding from Cisco switch. Is there any change required in routing entry? or ACL/POlicy Based routing require? IF so kindly Advice.
WHy I am trying to change cabling is "to share same traffic to both firewall" . So while failover since LACP 2 & 4 are shared will solve the traffic issue. Please advice on these also.I am confused in this part. Is there any alternative solution for this? Kindly advice. ( ALL TRAFFIC IS FINE BUT WHILE FAILOVER TRAFFIC TO SWITCH FAILS IN CURRENT SCENARIO)
IN SIMPLE TERMS : TRAFFIC IS NOT ROUTING TO FIREWALL AUTOMATICALLY AFER FIREWALL FAILOVER IN CURRENT SCENARIO. (THIS IS MY REAL ISSUE