Re: Failover not forwarding Traffic to Cisco 3750 from Juniper SRX 650- LACP Line

Dear Friend,

 I am little bit slow in Juniper config so am here for a solution ...

As per my view while failover testing happening POR CHANNEL 2 change to PORT CHANNEL 4 in switch side, but still traffic if sending to old interface because switch side interface is still UP, and due to  ARP traffic is forwarding.

1. AS YOU TOLD - IF I ADD ALL SWITCH PORT TO LACP 2 this issue will be solved ??? ( Because after this  there is only one LACP/ONE SUBNET,  backup line also in same VLAN)

2.Firewall side configuration doesnt have any entry for LACP 4 (192.168.51.1) ???( Better I will change switch side config  as stated in statement 1.)

Awaiting your valuable advice 

Thanks