Hi,
I hope somebody can help me with this setup.
We are trying to make a SRX240 cluster at two sites connected to each other with a fiber trunk (with all Vlan's at both sites). Site A and Site B are two different company's with theire own vlan's.
Below the situation we are trying to realize. 
It's important that:
- Devices in all VLAN's at site A, must use node 0, are using reth0 and must use the internet connection at site A.
- Devices in all VLAN's at site B, must use node 1, are using reth1 and must use the internet connection at site B.
When there's a problem with node 0 (site a), all traffic to the internet at site A, must flow via node1. Offcourse when this failover happens, the internet connections of site B must be used.
What have i done so far:
Created the cluster as in the picture. When node 0 is down, the traffic from a device to the redundant groups are flowing via node 1.
With priority values i gave reth0 a higher priority at node 0
With priority values i gave reth1 a higher priority at node 1.
This is working so far.
For choosing the right internet connection, I think i have to use two virtual routers and bind the right interfaces to the right virtual router. Virtual router 1 has an route to internet connecation site A, virtual router 2 has en route to internet connection site B.
I already tried this, but i can't set an physicial interface in the virtual router that is used in an redudant group. When i add the redundant interface to the virtual router it is working, but with an failover both redundant interfaces are still up-and-running, so i think the wrong virtual router will be used.
Can somebody help me with this setup. An example can be helpfull, but not necessarily needed. When somebody can tell me how this setup can work i can figure it out by myself.
Thanks
Jeroen