Thanks for the reply and advice.. I have attached the sample topo (SRV-1 and SRV-2 in the same vlan)
a) can i have more than one interface in a RETH (so in my case two interfaces each -- SRX-A and SRX-B)?
b) If the above is Yes then i need to create a L3 interface and then configure RETH to that right?
c) if a) is NO then the solution is only to create a AE in SRX-A and SRX-B and then configure RETH ? and so LAG should be supported by the Server... right?
d) If AE is not a option for me then can i use SWFAB for this solution with Ethernet Switching enabled on SRX-A and SRX-B?