Quantcast
Channel: All SRX Services Gateway posts
Viewing all articles
Browse latest Browse all 17645

Re: SRX 1500 Packet trace not working as expected

$
0
0

When I run 'monitor traffic interface reth2', I don't see the traffic I'm sending but there is stuff going on like below. The strange thing when I run the same command at the site where its all fine I dont see any traffic at all:

 

10:22:16.694642 In STP 802.1d, Config, Flags [none], bridge-id 8001.bc:c4:93:70:d5:00.8018, length 43
10:22:18.694993 In STP 802.1d, Config, Flags [none], bridge-id 8001.bc:c4:93:70:d5:00.8017, length 43
10:22:18.695122 In STP 802.1d, Config, Flags [none], bridge-id 8001.bc:c4:93:70:d5:00.8018, length 43
10:22:20.697309 In STP 802.1d, Config, Flags [none], bridge-id 8001.bc:c4:93:70:d5:00.8017, length 43
10:22:20.697437 In STP 802.1d, Config, Flags [none], bridge-id 8001.bc:c4:93:70:d5:00.8018, length 43
10:22:21.528845 Out arp who-has 10.0.5.2 tell 10.0.5.1
10:22:21.534881 In arp who-has 10.0.5.2 tell 10.0.5.1
10:22:22.700148 In STP 802.1d, Config, Flags [none], bridge-id 8001.bc:c4:93:70:d5:00.8017, length 43
10:22:22.700295 In STP 802.1d, Config, Flags [none], bridge-id 8001.bc:c4:93:70:d5:00.8018, length 43
10:22:24.704356 In STP 802.1d, Config, Flags [none], bridge-id 8001.bc:c4:93:70:d5:00.8017, length 43
10:22:24.704493 In STP 802.1d, Config, Flags [none], bridge-id 8001.bc:c4:93:70:d5:00.8018, length 43
10:22:26.705979 In STP 802.1d, Config, Flags [none], bridge-id 8001.bc:c4:93:70:d5:00.8017, length 43
10:22:26.706101 In STP 802.1d, Config, Flags [none], bridge-id 8001.bc:c4:93:70:d5:00.8018, length 43

 

10.0.5.2 = my reth2.0 IP

10.0.5.1 = Gateway IP on supplier side

 

Also just saw this:

Reverse lookup for 10.0.5.1 failed (check DNS reachability).
Other reverse lookup failures will not be reported.


Viewing all articles
Browse latest Browse all 17645

Trending Articles



<script src="https://jsc.adskeeper.com/r/s/rssing.com.1596347.js" async> </script>