Some notes on the annotations for your conversion.
The messages before line 89 can all be ignored.
These I am not sure what the tunnel option is for zones to a virtual router. This will need to be researched. I’ve not used this feature.
91:set zone "Untrust-Tun" vrouter "trust-vr"
Tunnel Zone is not supported in JUNOS
92:set zone id 100 "Paie" tunnel CH_Admin-sz
Line not yet supported by S2J
The Transparent mode messages can be ignored as you are clearly in layer 3 mode.
ethernet0/0
ethernet0/1
ethernet0/2
These configurations will need to be converted to units on the interface selected on your SRX with the VLAN tag added and family inet with the ip address from further down in the configuration.
IN the Security zone section you will need to add these interface sub units to the matching zone from the list
You can ignore vlan1 message in line 201 as this is part of transparent mode that you are not using.
You can ignore all the notes about ip manageable. The equivalent Junos is controlled by your zone host inbound services settings.
unset interface ethernet0/2.23 ip manageable
Messages in lines 245-253 can also be ignored.
NSRP: lines 254-266
Your ScreenOS is a cluster. The config here will be a single device not a cluster. You could get this running as a single device the run through the basic steps to join the two into a cluster. This will require making choices about redundancy on interfaces.
Alternatively you can design the cluster interfaces first and make the previous interface changes all the RETH interfaces to load into a basic cluster. In that case start by following the cluster kb to create the cluster then start merging in the rest of the config.
Address errors
281:set address "CH_Access-sz" "CCN Diameter VIP" 192.168.16.42 255.255.255.252
Invalid IP Address.Not accepted in Junos. Host IP should have /32 or 255.255.255.255 as mask.
this is saying you need to have the objects at the correct subnet boundaries in this case 192.168.16.40/30 instead of using 42
this also indicates boundary errors
Route interface cannot be null. Please define the interface.
address groups:
This is just the above addresses did not convert so the groups also failed and you manually create them
Member Definition for "LUVA VIP1" is missing or the member is not being converted.
You can ignore the messages in lines 652 to 665
This custom service does seem to be missing from the config and multiple rules depend on it.
680:set service "GTP"
Application Definition for "GTP" is missing or application not being converted.
The destination address "oss" is not defined in the CH_OM-sz zone
This is probably one of the addresses above that did not create so you will need to make the rule in addition to the address
you can ignore line 1922 as it only applies to NSM
This is controlled under system services if you need telnet
1926:set telnet client enable
Line not recognized by S2J
You will setup SNMP in Junos at hierarchy:
set snmp community
1930:set snmp port listen 161
There is no equivalent in JUNOS
You can ignore 1935
Routing 1980 and follows
Next Table Looping found. This route wont be converted.
These you will need to examine how the routes and the next table for the virtual routers work in Junos. Likely you can insert these into the desired routing-instance but will need to do this manually. This message mainly comes with the shared virtual router that exists in ScreenOS but not Junos.
line 2079 and similar are again indicating the need to use the base ip address of the subnet for these route entries.
10.177.32.1/24
not 10.177.32.51/24
2079:set route 10.177.32.51/24 interface ethernet0/1 gateway 192.168.16.253
Invalid IP Address. Not accepted in Junos. Host IP should have /32 or 255.255.255.255 as mask.