Hello,
I setup my SRX220 IDP for the 1st time today. I wonder why I don't see counters on traffic outbound? Do I also need to setup an inbound Policy? The Guest Network listed is an internal wifi network. I used the Recomended Option for the IDP.
My Config and outcome shown below. Thank you in adavance - Scott
> show security idp status
State of IDP: Default, Up since: 2016-04-15 17:03:27 EDT (37w4d 23:41 ago)
Packets/second: 0 Peak: 0 @ 2016-12-30 11:31:18 EST
KBits/second : 0 Peak: 0 @ 2016-12-30 11:31:18 EST
Latency (microseconds): [min: 0] [max: 0] [avg: 0]
Packet Statistics:
[ICMP: 0] [TCP: 0] [UDP: 0] [Other: 0]
Flow Statistics:
ICMP: [Current: 0] [Max: 0 @ 2016-12-30 11:31:18 EST]
TCP: [Current: 0] [Max: 0 @ 2016-12-30 11:31:18 EST]
UDP: [Current: 0] [Max: 0 @ 2016-12-30 11:31:18 EST]
Other: [Current: 0] [Max: 0 @ 2016-12-30 11:31:18 EST]
Session Statistics:
[ICMP: 0] [TCP: 0] [UDP: 0] [Other: 0]
Policy Name : Recommended
Running Detector Version : 12.6.160161014
-------------------------------------------------------------------
#set security policies from-zone Guest to-zone Internet policy idp-app-policy-1 match source-address any destination-address any application any
#set security policies from-zone Guest to-zone Internet policy idp-app-policy-1 then permit application-services idp
> show security policies
From zone: Guest, To zone: Internet
Policy: Guest, State: enabled, Index: 13, Scope Policy: 0, Sequence number: 1
Source addresses: any-ipv4
Destination addresses: any-ipv4
Applications: any
Action: permit
Policy: idp-app-policy-1, State: enabled, Index: 12, Scope Policy: 0, Sequence number: 2
Source addresses: any
Destination addresses: any
Applications: any
Action: permit, application services