Re: DHCP option 121. how to specify /16 mask?
nope =)need some internal documentation or success story.KB is complete useless because of no explanation
View ArticleHOW TO BUNDLE LAYER 3 INTERFACES ON SRX 1500
Hello, I have SRX 1500 and i want to bundle to the XE ports and assign IP addresses to them, how can i do it? Thank you in advance.
View ArticleRe: DHCP option 121. how to specify /16 mask?
agree, but I know that option 121 is an array of unsigned interger. So try the array I have sent with byte or unsigned-integer instead of integer.
View ArticleRe: DHCP option 121. how to specify /16 mask?
I've read rfc.according it my config have to be:set system services dhcp option 121 array ip-address 16.172.16set system services dhcp option 121 array ip-address 192.168.55.1as explained at page...
View ArticleRe: DHCP option 121. how to specify /16 mask?
Try this one : set system services dhcp option 121 array string 0x10AC10C0A83701
View ArticleRe: Proxy-ID
I can use cisco asa with crypto maps in one side and srx with traffic-selector in the other side, with no problem. I have this deployed and working fine .
View ArticleSRX - MPLS as primary path / IPSEC VPN as secondary path
Hi all,i would like to know if someone can suggest how i can deploy the following scenario: 1- one path through the trust zone connect to destination through mpls link;2- if the mpls link goes down,...
View ArticleRe: HOW TO BUNDLE LAYER 3 INTERFACES ON SRX 1500
Here is an example of setting up the AE bundle between the SRX and EX https://kb.juniper.net/InfoCenter/index?page=content&id=KB22474
View ArticleRe: SRX - MPLS as primary path / IPSEC VPN as secondary path
Hello, You can refer to link below for reference:- https://kb.juniper.net/InfoCenter/index?page=content&id=KB29227 Regards, Rushi
View ArticleRe: Question abot logical-systems and address-book
Yes you can, at least the CLI support.BTW, lsys can only be supported on HE.
View ArticleRe: SRX240 Change the Broadband IP
Hello, The default route can be set 2 routing? The new IP and gateway is different by existing. Thanks!!!
View Article(Juniper SRX) Configure dual internet connection
Hello, i want to ask,i have 2 internet connection with static ip public and i want to configure my juniper srx 100 with scenario like this: a. user with ip address list 1-30 connect to internet with...
View ArticleRe: (Juniper SRX) Configure dual internet connection
I believe this KB explains the same scenario as your requirement.http://kb.juniper.net/KB23300
View ArticleRe: (Juniper SRX) Configure dual internet connection
Hi,Yes you can do this.Put both the ISPs in different routing instance.keep one in inet.o and the second one in another routing instance.create firewall filter to route trafficfilter term 1 will have...
View ArticleRe: SRX240 Change the Broadband IP
You may try load-bancing (https://kb.juniper.net/KB23417)of traffic between these 2 links or do policy based routing (http://kb.juniper.net/KB23300) and send few subnet traffic via 1 link and others...
View ArticleRe: SRX - MPLS as primary path / IPSEC VPN as secondary path
Just a thought, run BGP between MPLS and VPN end points . Import routes from MPLS with Priority 2 and Route from VPN with priority 3 .
View Article