Re: Juniper SRX220H device returns to factory
Its most probably due to file system corruption and device is not able to read the config files. The best solution would be to recover the device using a snapshot taken from another device. Step 1.Plug...
View ArticleRe: SRX site-to-site vpn slow in one direction
you ahve configured these MSS/MTU settings on both sides? Do you see any high CPU/memory issues?
View ArticleRe: Juniper SRX 100 no storage error
it will automatically boot from USB. If USB is not found it will try to boot from CF.
View ArticleRe: Custom user permissions
Hi, Please test below : set system login class TEST permissions allset system login class TEST deny-configuration-regexps "system login"
View ArticleCant figure out policy dropping traffic
Hi, I havea system setup as follows: Juniper SRX ge-0/0/0 attached to cellular provider on private APN2 cellular routers (default route from provider is to the srx)gre tunnel between each cellular...
View ArticleRe: srx-210 boot issue
Choppy148, Use this procedure. The starting portion describes how to set the environment variables from the prompt you have. the bottom portion gives the install instructions from the USB drive...
View ArticleRe: Cant figure out policy dropping traffic
Sorry, I'm have trouble picturing the topology. So the key here is to understand:Ingress interface where the ping comes in from the cell modem (this interface is assigned to the source zone)egress...
View ArticleRe: Juniper SRX220H device returns to factory
Are you saying the SRX fails and just comes up at factory default? Perhaps you had a power outage the the SRX is booting from the snapshot that is still the factory default. After you get the device...
View ArticleRe: Juniper SRX 100 no storage error
I was also suggesting that you confirm the created USB does successfully boot the known good SRX. This will confirm that the USB itself is a compatible model. There are some that won't work as boot...
View ArticleSRX 300 RSTP?
Have an SRX300 on 15.1X49-D60.7, and get the message "unsupported platform (srx300)" when trying to configure RSTP. Do these routers have any spanning tree abilities? Anything you can do to prevent...
View ArticleRe: SRX 300 RSTP?
Hi, RSTP is not supported on the SRX300 as of now.Its support would be available from 15.1X49-D70.Tentative release date is 17th November. Regards,Sahil...
View ArticleRe: SRX site-to-site vpn slow in one direction
Yes the same mtu/mss on both sides. cpu and memory usage are low. Ive even run up a pair of SRX in a lab and get the same behaviour.
View ArticleRe: Reachability Issues With SRX Routers and OSPF
That seems to have resolved the problem! I'll have to get into the JNCIS-SEC to better understand the firewalls on the SRX platform. Thanks!
View ArticleRe: Proxy-arp on redundancy interface
Yes, I can commit this config without any problems/errors too.The problem is that I can't send packets from host 10.0.0.2 to host 10.0.0.3. That's happening simply because SRX doesn't answers to...
View ArticleRe: High system CPU usage when using screen to limit udp flood
Hi, Thanks for the hint. Configured the stream mode and remote server. Runs fine with the same test. FPC 0 PIC 0 CPU utilization : 6 % node0:...
View ArticleIP Sec VPN with Checkpoint and Proxy ID
Hi , I have a question about IP Sec VPN Connection Checkpoint > Juniper Some times I found error message from checkpoint "no response from peer. IKE failure " As i check on juniper srx did't...
View Article